- Automatic Remote Antenna Switch with 6 antennas by 3 radios.
- Composed by the set AS-61RL and RC-603VR
- Works from 1.8 MHz to 148 MHz
- Control for two Rotors.
- Command over RF cable.
- RS-232 communication port
- Inteligent band decoder and antenna memory.
- All antennas and radios are switched to ground when not in use.
- Non-simultaneous operation.
- Automatic operation compatible with: ELECRAFT, KENWOOD, YAESU, ICOM, FLEX Radio or any other Radio that uses one of these communication protocols.
- Manual operation with any radio.
AS-603-VR Automatic HF and VHF Wireless Antenna Switch & Rotator Control
US$ 768,00
Description
The AS-61RL / RC-603VR set is an automatic antenna switch for three radios and six antennas. There are two independent boxes, one for the antenna switch that is near the antennas, AS-61RL, and another box with the Push Buttons for the selection of the antennas and the Radios, RC-603VR, that is next to the Radio. The connection between the two boxes is only made by the RF cable (RG-58 or RG-213). This cable takes RF, power and the necessary commands for the perfect operation of this system. The operation is individual, which means that only the selected radio will have access to the antennas. Unused antennas are automatically short circuited. To facilitate the operation, the RC-601VR also has a third internal switch that switches the Send commands and the Com port to the selected Radio.
The RC-603VR also has a controller for two rotators, consisting of a three-digit display and an encoder to select the azimuth. All commands to the rotor are sent over RF cable to the AS-61RL which transfers them to the rotors.
The AS-61RL / RC-603VR supports communication with the following radios:
Icom (CI-V), Kenwood (RS-232), Elecraft K3 (RS-232), Yaesu (RS-232), Flex Radio or any other Radio that uses one of these communication protocols.
Specification:
|
Size AS-61RL:
|
Width 22cm – Height 10cm – Deep 13cm |
|
Size RC-603VR:
|
Width 29cm – Height 8cm – Deep 17cm |
|
Power Supply:
|
D.C. 14 Volts + or – 20% drain about 190mA |
|
Max. SSB power allowed:
|
2500 Watts P.E.P. with S.W.R. equal or less than 1.7:1 ( HF ) |
|
Frequency of operation:
|
1.8 MHz to 148 MHz |
|
Insertion loss:
|
Equal or less than 0,2dB |
|
Port Isolation:
|
Typical 55db |
| Six antennas, three radios, one linear amplifier block diagram. |
|
|
Downloads:
Additional information
| Weight | 2,4 kg |
|---|---|
| Dimensions | 32 × 30 × 14 cm |
